2010 Dodge Ram Headlight Removal

24 Oct 2023

You will need a 10mm socket wrench and a few extensions. Hope this saves everyone some time.

2010 dodge ram headlight replacment/removal YouTube

2010 Dodge Ram Headlight Removal. Web how to remove headlights without removing the grill!!!big thanks to corneileous from dodge ram forums for telling me this. Remove the air intake mechanism. Locate the two bolts on the top of the assembly and remove them with your wrench or socket.

Web Replacing The High Beam.

Work small amounts of polish into the lens one at a. High beams are a bugger, but removing stuff from the inside to get to them is possible. Push white tab up to release headlight, not down.

You Have To Gently, But Firmly, Pull.

If you have been driving your dodge ram for a while, your headlights may start misbehaving by going on and off without you touching. Web how to remove headlights without removing the grill!!!big thanks to corneileous from dodge ram forums for telling me this. Disconnect and isolate the negative battery cable.

Web How To Disassemble Your Headlights On Your Dodge Ram.

Before beginning, make sure your truck is turned off and the engine has cooled. Locate the green turn signal wire clamp. Headlights going on and off occasionally.

Remove The Old Headlight Assembly.

You will need to remove the front grill (4 10mm bolts and 4 plastic body. Use a flathead screwdriver to pry up one side of the clamping teeth and pull the connector off. Hope this saves everyone some time.

Web Paul Shows How To Replace Your Headlight Or Just Your Bulb And Breakes It Down So You Can See Exactly How To Do It Like A Pro.

Web in this video we show how to remove the front grille assembly and headlights in order to change the bulbs on your 2009 2010 2011 2012 2013 2014 2015 2017 201. Set them some place safe. Easy step by step instructions.

Pull The Hood Latch Under The Driver's Steering Wheel.

Locate the blue headlight wire. You will need a 10mm socket wrench and a few extensions. Once the new headlight is in, place it back into the housing unit, and pop back in the headlight retaining tab.